Select The Interface Type; Interface Selection; Configuring The Interface - Datalogic Gryphon I GM4100-BK Quick Reference Manual

Select the Interface Type

Upon completing the physical connection between the reader and
its host, proceed directly to Interface Selection on page 19 for in-
formation and programming for the interface type the reader is
connected to (for example: RS-232, Keyboard Wedge, USB, etc.)
and scan the appropriate barcode to select your system's correct
interface type.

Interface Selection

Each reader model will support one of the following sets of host
interfaces:
General Purpose Models:
board Wedge
Retail Point of Sale Models :
46XX

Configuring the Interface

Scan the programming barcode which selects the appropriate in-
terface type matching the system the reader will be connected to.
Next, proceed to the corresponding chapter in the Gryphon™ I
GD4100/GM410X PRG to customize any settings and features
associated with that interface.
Quick Reference Guide
RS-232, RS-232 OPOS, USB, Key-
RS-232, RS-232 OPOS, USB, IBM
Unlike some other programming features and options,
interface selections require that you scan only one
programming barcode label. DO NOT scan an ENTER/
EXIT barcode prior to scanning an interface selection
barcode.
Some interfaces require the scanner to start in the dis-
abled state when powered up. If additional scanner
configuration is desired while in this state, pull the
trigger and hold for 5 seconds. The scanner will change
to a state that allows programming with barcodes.
Select the Interface Type
19