Select The Interface Type; Interface Selection; Configuring The Interface - Datalogic Gryphon GM410X Quick Reference Manual

Select the Interface Type

Select the Interface Type
Upon completing the physical connection between the
reader and its host, proceed directly to
on page 18 for information and programming for the
interface type the reader is connected to (for example: RS-
232, Keyboard Wedge, USB, etc.) and scan the appropriate
barcode to select your system's correct interface type.

Interface Selection

Each reader model will support one of the following sets
of host interfaces:
General Purpose Models —
board Wedge
Retail Point of Sale Models —
IBM 46XX

Configuring the Interface

Scan the programming barcode which selects the appro-
priate interface type matching the system the reader will
be connected to.
Next, proceed to the corresponding chapter in the Gry-
phon™ I GD4100/GM410X PRG to customize any settings
and features associated with that interface.
18
Unlike some other programming features and
options, interface selections require that you
scan only one programming barcode label. DO
NOT scan an ENTER/EXIT barcode prior to
scanning an interface selection barcode.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while in
this state, pull the trigger and hold for 5 sec-
onds. The scanner will change to a state that
allows programming with barcodes.
RS-232, RS-232 OPOS, USB, Key-
RS-232, RS-232 OPOS, USB,
Interface Selection
Gryphon™ I GM410X