Getting Started
Using the Programming Barcodes
This manual contains feature descriptions and barcodes which allow you to reconfigure your
reader. Some programming barcode labels, like the
Defaults on page
programming labels in this manual, however, require the reader to be placed in Programming
Mode prior to scanning them. Scan an ENTER/EXIT barcode once to enterProgramming
Mode. Once the reader is in Programming Mode, you can scan a number of parameter settings
before scanning the ENTER/EXIT barcode a second time, which will then accept your changes,
exit Programming Mode and return the reader to normal operation.
Select the Interface Type
Upon completing the physical connection between the reader and its host, proceed directly to
Interfaces on page 11
connected to (for example: RS-232, Keyboard Wedge, USB, etc.) and scan the appropriate bar-
code in that section to select your system's correct interface type.
Configure Interface Settings
If after scanning the interface barcode from the
you to select options to further customize your reader, turn to the appropriate section for your
interface type as listed below:
•
•
•
•
•
Configure Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
General Features
indicators and other such universal settings.
Symbologies
tings allow you to enable/disable symbologies, set label lengths, require check digit, etc.
8
9, require only the scan of that single label to enact the change. Most of the
There are some exceptions to the typical programming sequence
described above. Please read the description and setting instruc-
tions carefully when configuring each given programmable feature.
NOTE
for information and programming for the interface type the reader is
RS-232 ONLY Interface, starting on page 45
Keyboard Interface, starting on page 71
USB-OEM Interface, starting on page 85
IBM 46XX Interface, starting on page 89
Wand Emulation Interface, starting on page 95
—
General Features includes programming for scanning, beeper and LED
—
Includes options concerning the barcode label types (symbologies). These set-
Resetting the Product Configuration to
Interfaces
section, your installation requires
PowerScan
TM
PD7100 Corded