Table of Contents
Advertisement
TILTING INSTRUCTIONS
Your kettle has the standard "Clean Lock" feature and may not be tilted without disengaging the
tilt knob located on the console at the top left. This feature locks the kettle in the upright
position and also allows the operator to lock the kettle at 105 degrees for ease of cleaning.
Follow these steps to tilt kettle:
1. Pull out the tilt knob at the top left of console.
2. Using kettle tilt handle, pull kettle forward to desired angle of pour or until kettle locks at 105
degrees. The tilt knob can be released after the kettle has been tilted approximately 10
degrees.
3. Kettle will lock in position at 105 degrees and may be tilted further by pulling the tilt lock
knob a second time allowing the kettle to tilt the full distance.
4. To return the kettle to the upright position, pull out the tilt lock knob and tilt the kettle upward
until it locks in the upright position. The kettle should not move in either direction once in the
upright position.
LIGHTING
1. Ensure the kettle is in the upright position.
2. Open the manual gas shut off valve located at the back of the right-hand console when
facing the front of the unit.
3. Set the thermostat dial in off position. Turn the power switch on.
4. Set the thermostat to desired setting. NOTE: Ignition may not occur at a setting below 2 - 3
on thermostat dial. If ignition light does not stay on, turn off thermostat. Wait five minutes
and repeat the lighting procedure.
WARNING: In the event of main burner ignition failure, a 5 minute
purge period must be observed prior to re-establishing ignition source.
SHUT DOWN
1.
Turn thermostat dial to "OFF" position.
2.
Turn power switch to "OFF" position.
3.
Close manual gas shut-off valve.
10
Advertisement
Table of Contents
