Log Shipping Bracket; Decorative Brick Panel Installation - Napoleon Park Avenue Series Installation And Operating Instructions Manual

34
6.3

LOG SHIPPING BRACKET

Before installing the logs, you must rst remove the log shipping brackets. Lift up
to remove.
EN
6.4

DECORATIVE BRICK PANEL INSTALLATION

Decorative panels may discolor after time.
A. Carefully remove the glass door and all logs see
"FINISHING" section.
B. Remove the two screws holding the front portion of the rear
air de ector. Remove the pilot shield by removing the two
screws as illustrated.
C. Remove the 3 screws securing the burner down and
carefully remove the burner. Do not remove the screws and
washers securing the bre burner cover.
D. Install the right brick panel by sliding the bottom edge of the
panel down the right rebox side then pivot the top edge of
the panel into place against the rebox wall. Hold in place
with the brick retainers.
E. Rest the bottom edge of the rear panel on top of the rear
portion of the air de ector at the back of the rebox and
push into place. The rear panel is held in place when both
side panels are in position.
F. Install the left brick panel using the same method described
in step 4.
G. Replace the burner, air de ector, logs
and glass door.
NOTE: Due to the brittle material of the
bricks, care must be taken not
to bend or force them into place.
Refractory panels require a 24 hour
curing period on a low fl ame.
LOG SHIPPING
BRACKET
STEP
B
PILOT SHIELD
STEP
C
E
D
HERRINGBONE PATTERN ILLUSTRATED
F