Installation - Chicago Electric 93881 Assembly And Operating Instructions Manual

4. If necessary, continue adding engine oil, while rechecking the Oil Dipstick, until
the oil level reaches the "MAXIMUM" indicator on the Oil Dipstick.
Do not exceed the "MAXIMUM" indicator mark on the Oil Dipstick.
(See Figure A.)
5. When finished adding engine oil, carefully screw the Oil Dipstick back into the
Dipstick Hole. Then, replace the Oil Dipstick Cover (12B). (See Figure B.)
To Fill The Fuel Tank:
1. Prior to first using the Generator, the Fuel Tank (19B) MUST be filled with
unleaded gasoline. (See Figure C.)
2. To do so, remove the Fuel Tank Cap (5B) and fill the Fuel Tank with unleaded
gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Fuel Tank
(19B) for the amount of unleaded gasoline. When necessary, refill the Fuel Tank.
(See Figure C.)
3. NOTE: Periodically, make sure to check the Fuel Filter (4B) for excessive dirt
and debris. If necessary, remove the Fuel Filter and clean with compressed air.
(See Figure C.)
FUEL FILTER
(4B)
FIGURE C

Installation:

1. Electrical and other permits may be required for the installation of emergency or
portable power systems. Investigate the local building and electrical codes
before installing this unit.
2. Prior to providing Generator power to tools and equipment, make sure the
Generator's rated voltage, wattage, and amperage capacity is adequate to
SKU 93881 For technical questions, please call 1-800-444-3353
FUEL TANK CAP
(5B)
PAGE 9