Vinotemp element EL-168COMML Owner's Manual page 12

Power
7
V
To control the appliance turn on/off. To turn off the appliance, touch the mark and
I
hold for at least 5 seconds. Press
readout will show the original temperature set previously when restart the appliance
N
or reconnect after power cuts .
O
Light switch
T
E
M
P
.
Light switches are under the control panel to control the lights turn on/off :
C
LED light for two side;
1
O
Orange backlight;
2
Blue backlight;
3
M
When turn on Blue/Orange backlight at the same time, The color vary by optical action.
Donʼt turn on the backlight synchronously for a long time, otherwise that cause raise the consumption.
Setting the Temperature Control
You can select temperature display setting from Fahrenheit to Celsius degree by
touching the ℃/℉ Selector mark. Fahrenheit or Celsius degrees indicator will appear
in blue color in the temperature display window for each zone. You can set the
temperature as you desire by touching the UP and DOWN marks. When you touch the
two marks for the first time, the LED readout will show the original temperature set
previously.
 The temperature that you desire to set will increase 1℃ or 1℉ if you touch the
UP mark once, on the contrary the temperature will decrease 1℃ or 1℉ if you
touch the DOWN mark once.
 Temperature range : 5-18℃/41-64℉
 The temperature inside the unit will be appeared in blue color in the display
window.
Shelves
 To prevent damaging the door gasket, make sure the door is fully open when
pulling shelves out of the rail compartment.
 For easy access to the bottles stored, pull the shelves out approximately
The shelves are designed with
12
again, turn on the appliance. The LED
slider.
W W W . V I N O T E M P . C O M
100%.
T E M P . C O M