Table of Contents
Advertisement
7. MOUNTING THE POWER CORD BRACKET
Parts Required:
1
x
Power Cord Bracket (#10)
2
x
#10–24x½" Screw ( #D)
Installation:
•
Locate the two holes on the bottom of the (left side) support panel. Mount
the power cord bracket to the support panel using two screws, as shown in 7A.
•
Next, loosen the nut on the pre-mounted clip bracket and guide the
power cord through the clip bracket. Once through, tighten the nut,
and wrap the power cord on the bracket until unit is in use. Note 7B, 7C.
8. SECURING THE GREASE TRAY BRACKETS
Parts Required:
1
x
Wire Components Housing (#18)
Grease Tray Brackets (#17)
2
x
#10–24x½" Screw ( #D)
6
x
Installation:
•
First, mount the wire components housing onto the base of the auger
housing using two screws in each bracket. Note 8A.
•
Secure the grease tray brackets onto the base of the auger housing
and the wire components housing using two screws in each bracket.
Note illustration 8B for proper placement.
NOTE: The diveted end of the brackets should face the control board.
•
Fully-tighten all screws on the cart base. Next, carefully turn the unit
into an upright position, with the wheels on the bottom. Ensure its level.
9. PLACING THE GREASE TRAY
Parts Required:
Grease Tray (#16)
1
x
Installation:
•
Slide the grease tray into the grease tray brackets on the front
underside of the main cabinet, under the control board.
NOTE: The grease tray is completely inserted once the front of the
tray is pushed in as far as it can go, with no gap between the grease
tray and the front panel.
10. ATTACHING THE HOPPER CLEAN-OUT DOOR KNOB
Parts Required:
1
x
Door Knob (#A)
Installation:
•
Attach the door knob to the hopper clean-out door by rotating the
part into the hole on the door. Rotate until completely fastened and
clean-out door latch is secured.
NOTE: To use the hopper clean-out feature, simply loosen the door
knob, raise the clean-out door latch and open the door.
7A
7B
D
11
7C
8A
8B
17-1
17-2
9
FRONT
10
18
17
A
9
Hide quick links:
Advertisement
Table of Contents
