Table of Contents
Advertisement
Chapter 2
*4 Function "64 (EMR)" cannot be assigned to input terminal 3 by an operation from the digital operator. The function is automatically
assigned to the terminal when slide switch SW1 is set to ON.
*5 After slide switch SW1 has been set to ON once, function assignments to intelligent input terminals [1] and [3] are not returned to their
original assignments. If necessary, re-assign original functions to the intelligent input terminals.
Note: If the data of an optional operator (WOP, SRW or SRW-EX) is copied:
If operator data is copied to your SJ700 series inverter whose slide switch SW1 is ON from another SJ700 series
inverter whose slide switch SW1 is OFF or an SJ300 series inverter, the digital operator on your SJ700 series
inverter may display [R-ERROR COPY ROM] for a moment. This event may occur because the data on intelligent
input terminals [1] and [3] cannot be copied since, on your inverter, exclusive functions have already been
assigned to intelligent input terminals [1] and [3] due to the slide switch SW1 setting to ON. Note that other
data is copied. If this event occurs, check the settings on both copy-source and copy-destination inverters.
Note: Slide Switch 12
Some models have slide switch in the position as shown below. Default setting of this switch is at "ON"
position.
Please don't change the setting. If it is changed, inverter may trip and disabled to run.
Slide switch SW1
Slide lever (factory setting: OFF)
OFF
ON
Slide switch SW12
OFF
ON
Slide lever
(factory setting: ON)
Logic board
2-10
Installation and Wiring
Advertisement
Table of Contents
