Code Identification; Sleep Timer; Code Learning; Tips On Learning - Zenith ZN551 Manual

Code Identification

Code Identification
1. Press and hold Code Search button until the red indicator
stays on. Release the Code Search button.
2. Press and release the desired mode button (TV, VCR, etc.).
The red indicator blinks, then stays lit.
3. Press and release the Code Search button. The indicator light
blinks off.
4. To find the first digit for the code stored under the mode key
pressed in step 2, press each numeric key from 0-9 in turn.
When the indicator light blinks off the number you pressed is
the first digit for the code you are searching for.
5. To find the second digit, repeat step 4, this time when the
indicator light blinks off this is the second digit.
6. Repeat step 4 again to find the third digit.
The Sleep feature enables the remote to turn off the TV after a
period of 1 to 99 minutes. Remote is to be in TV mode to set a
Sleep Timer. This feature works even if your TV does not have this
feature.
2.
1, 3.
4.
IN FO/
SEL EC T
GU IDE
12

Sleep Timer

1. Press and release the TV Mode key.
2. Press and hold the Sleep button until LED remains on (occur-
ring after approx. 2-3 seconds).
3. Release Sleep button.
4. Press and release the numeric keys (01-99) for the time
required. The LED will blink off to indicate keypress accep-
tance and remain off after second keypress.
5. TV Sleep Timer now set.
6. Leave the Remote pointing towards the TV with an unob-
structed path.
To cancel the Sleep Timer, press and hold the Sleep key until the
LED blinks or press and release the Power key in TV Mode.

Code Learning

Tips On Learning

1. Use fresh batteries for both the Learning Remote and the
Original Remote.
2. Perform a Master clear (see page 15) before learning.
3. Place the original remote end-to-end with the Learning Remote
so the IR transmitters on both remotes are directly in line with
each other. Keep the two remotes approximately one inch away
from each other.
4. Experiment by learning 2 or 3 commands initially (to ensure
compatibility and familiarity) and then carry out a Master Clear
before completely learning your original remote's commands.
5. Do not try to learn directly under an incandescent or low-
energy light as these can cause interference with learning. Keep
at least three feet away from any such light sources.
13