Programming Cable Boxes; Programming With Code Search; Programming Aux Devices; Code Identification - Zenith ZEN100 User Manual

PROGRAMMING CABLE BOXES

1. Manually turn on the Cable Box.
2. Press and hold the CODE SEARCH button until the
Indicator Li ght lights, then release the CODE SE ARCH
button.
3. Press and release the CBL button (the Indicator Light
will blink and then remain lit).
4. Find the three digit code for your Cable box in the
code list and enter it using the Number Buttons. After
your code is entered, the Indicator will turn off.
Note: If the LED blinked rapidly when you entered the
code, you may have entered an invalid code. Recheck
the code list and try again.
5. Now check to see if the correct code was entered.
With your TV and Cable Box on, press some of the
buttons. If the Cable Box responds correctly to each
of the buttons, no further programming is required.
Note: If some buttons do not operate your equipment, try
one of the other codes or our brand.
6. Write down the code for future reference.

PROGRAMMING AUX DEVICES

Aux buttons allow you program a CD, second TV, satel-
lite system or second VCR.
1. Manually turn on the device you wish to program.
2. Press and hold the CODE SEARCH button until the
Indicator Light lights, then release the CODE SEARCH
button.
3. Press and release the AUX button (the Indicator Light
will blink and then remain lit).
4. Find the three digit code for your device in the code
list and enter it using the Number Buttons. After your
code is entered, the Indicator will turn off.
Note: If the LED blinked rapidly when you entered the
code, you may have entered an invalid code. Recheck
the code list and try again.
5. Now check to see if the correct code was entered.
With your device on, press some of the buttons. If
the device responds correctly to each of the buttons,
no further programming is required.
Note: If some buttons do not operate your equipment, try
one of the other codes or our brand.
6. Write down the code for future reference.
7. Repeat these steps for the other AUX buttons.
ZENITH REMOTE MANUAL
ZEN REMOTE PROGRAMMING
4

PROGRAMMING WITH CODE SEARCH

If your code for your TV, VCR, Cable Box, Satellite, Home
Control, or CD Player is not listed, try the following pro-
cedure to find the code for your device.
1. Manually turn on the device you wish to program.
2. Press and hold the CODE SEARCH button until the
Indicator Light turns on, then release the CODE
SEARCH button.
3. Press TV, VCR, CBL, or AUX (depending on which
device you wish to program). The Indicator Light
will blink again then remain lit.
4. Cycle through the codes by pressing and releasing
the POWER button. Keep pressing POWER until the
device shuts off, this may take up to 300 tries. (If
skip over a code, press CHANNEL DOWN to back up)
5. Press MUTE to complete setup.
6. Now read below to learn how to identify your code
number for future use.

CODE IDENTIFICATION

1. Press and hold CODE SEARCH until Indicator Light
turns on. Release CODE SEARCH button.
2. Press and release desired Mode button (TV, VCR, CBL,
or AUX). Indicator Light will blink once to indicate
key-press acceptance.
3. Press and release the CODE SEARCH button. Indicator
Light will blink off to indicate key-press acceptance.
4. To find the first digit, press the numeric keys from 0
to 9. When the Indicator Light blinks off and on
once, that number is the first stored digit. Repeat to
find the second digit.
5. To find the third digit, repeat step four. This time
the Indicator Light will remain off once the key
corresponding to the third digit is pressed.
6. Write down the code for future reference.
ZEN SERIES