Code Identification Feature; Sleep Timer; Programming Combo Device Codes; Vcr/Dvd/Dvr Punch-Through Feature - Zenith ZH210 Owner's Manual

Code Identification Feature

The Code Identification Feature allows you to identify the 4 digit
library code stored under your device key. For example, if you
want to find out what 4 digit code is stored under your TV device
key, follow the six steps below:
1. Press and hold the CODE SEARCH button until the red indica-
tor stays on. Release the CODE SEARCH button.
2. Press and release the desired mode button (TV, VCR, etc.). The
red indicator blinks, then stays lit.
3. Press and release the CODE SEARCH button. The red indica-
tor blinks off.
4. To find the first digit for the code stored under the mode key
pressed in step 2, press each numeric key from 0-9 in turn. When
the red indicator blinks off the number you pressed is the first digit
for the code you are searching for.
5. To find the second digit, repeat step 4, this time when the red
indicator blinks off this is the second digit.
6. Repeat step 4 to find the third and fourth digits.

Sleep Timer

The SLEEP button operates the Sleep function of your device pro-
viding it supports the Sleep function. Alternatively, you can enable
the remote to turn off your TV after a period of 1 to 99 minutes as
shown below. This feature is only available for the TV Mode and
the remote must be in TV Mode to set a Sleep Timer. This feature
works even if your TV does not have its own Sleep function.
1. Press and release the TV Mode button.
2. Press and hold the CODE SEARCH button until the red indica-
tor stays on. Release the CODE SEARCH button.
3. Press and release the SLEEP button (Note any previously set
Sleep timer is cancelled at this point and the remote returns to
normal operation).
4. Press and release the numeric buttons (01-99) for the time
required. The red indicator blinks off to indicate button press
acceptance and remains off after the second button press.
5. TV Sleep Timer now set.
6. Leave the Remote pointing towards the TV with an unob-
structed path.
To cancel the Sleep Timer, press and release the POWER button in
TV Mode or repeat Steps 1, 2 and 3 above.

Programming Combo Device Codes

Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/ VCR, etc.)
will require you to set up two different Mode buttons to control
both parts of the Combo device. For example, if you have a
TV/DVD Combo, you might need to set up one code under the TV
button to control the TV part AND a separate code to control the
DVD part.

VCR/DVD/DVR Punch-Through Feature

This remote allows the 6 VCR transport buttons (i.e. PLAY,
PAUSE, STOP, FF, REWIND, and REC) to Punch- Through
control from TV Mode to VCR/DVD Mode you used. This feature
will not operate if the programmed TV, SAT or Cable code has its
own VCR transport button control e.g. a TV Combo, SAT/PVR, etc
7