Advertisement
Step 8
EB21
(82)
The wall panels come in two widths.
Each wall panel has a crimped rib
on one side. The crimped rib should
go under the rib of the panel that
follows it.
1
Locate all of the wall panels and
set each one alongside the building.
2
Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and determin-
ing if the holes line up with the holes
in the frame.
3
Fasten the wall panels at the top
and bottom with screws.
4
Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with two screws.
5
When you have attached all wall
panels in the correct positions, the
building will look like this.
Parts Needed For
Wall Panels
(11)
6627
6627
STEP
3
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
STEP
5
STEP
1
6915
Panels rest on
frame as shown
Crimped Rib
Underneath
21
6627 Wall Panel (4)
6915 Wall Panel (2)
6915
Detail Showing
Center of Panel
Screwed to
Wall Channel
Bolt and nut
does not go thru
STEP
wall channel
at overlap
4
STEP
2
6627
6627
Advertisement
