Advertisement
Step 6
T19 ctr
(14)
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this
point if you do not have enough time to
complete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
CORRECT
1
Position the rear corner panels
at the rear corners, as shown. The
widest part of each rear corner panel
must be placed along the rear of the
building. Attach the corner panels to
the oor frame with four screws.
2
Position a front corner panel
at the corner of the oor frame as
shown. The widest part of each front
corner panel must be placed along
the front of the building. A small gap
will exist between front corner panel
and ramp. Fasten the corner panel
to the oor frame with three screws.
NOTE
Be careful to install the correct
panel in each position as shown
3
Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must be square
and level or holes will not align.
STEP
STEP
INCORRECT
Parts Needed For
Corners
9386
Narrow Side
1
SIDE
2
9382
STEP
3
9382
Panels rest on
frame as shown
19
9382 Front Corner Panel (2)
9386 Rear Corner Panel (2)
Wide
Side
REAR
TOP VIEW
FRONT
9386
9386
SIDE
9382
9386
9382
Washer
Advertisement
