Table of Contents
Advertisement
PREPARATIONS > Configuring the speaker settings
Error messages from YPAO
If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO
again.
[Search tag]#Q03 YPAO Error
Error message
E-1:No Front SP
E-2:No Sur. SP
E-5:Noisy
E-7:No MIC
E-8:No Signal
E-9:User Cancel
E-10:Internal Err.
NOTE
To exit the YPAO measurement for resolving the problem, press ENTER, and select "EXIT".
(
For the E-5 and E-9 messages only, you can proceed with the YPAO measurement. Press ENTER, and select "PROCEED".
(
To retry the YPAO measurement from beginning, press ENTER, and select "RETRY".
(
Remedy
Exit YPAO, turn off the unit, and then check the speaker connections.
Keep the room quiet and retry YPAO. If you select "PROCEED", YPAO takes the
measurement again and ignores any noise detected.
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO.
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error
occurs repeatedly, contact the nearest authorized Yamaha dealer or service center.
Retry or exit YPAO as necessary.
Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the
nearest authorized Yamaha dealer or service center.
77
Advertisement
Table of Contents
