Table of Contents
Advertisement
PREPARATIONS > Configuring the speaker settings
6
According to the guidance displayed on the screen, start the measurement.
The following screen appears on the TV when the measurement finishes.
After confirming the measurement results, press ENTER.
a
The number of speakers (front side/rear side/subwoofer)
b
Speaker distance (nearest/farthest)
c
Adjustment range of speaker output level
d
Warning message (if available)
7
Select "Save" to apply the measurement results to the speaker settings.
8
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
NOTICE
The YPAO microphone is sensitive to heat, so should not be placed anywhere it could be exposed to direct sunlight or high
(
temperatures (such as on top of AV equipment).
NOTE
An error message may appear during the measurement.
(
To cancel the operation, disconnect the YPAO microphone before starting the measurement.
(
Related links
"Setting the speaker impedance" (p.171)
(
"Assigning speaker configuration" (p.76)
(
"Error messages from YPAO" (p.77)
(
"Warning messages from YPAO" (p.78)
(
1
2
3
4
75
Advertisement
Table of Contents
