Advertisement
INSTALLATION INSTRUCTIONS
Fig.13
3 4 (or1
/2
)Long
Hex-head Screw
5
Install Suppor t Bracket
1. Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown in Fig.15A. Mark brackets at top level
of sill and remove.
2. Assemble sill angle bracket to support
brackets at the marked position(Fig.15B).
Hand tighten, but allow for any changes later.
NOTE: Check that air conditioner is tilted back about
1
5
1 / to 1 / (tilted about 3 to 4 downward to the outside).
4
8
After proper installation, condensate should not drain
from the overflow drain hole during norma l use, correct
the slope otherwise (Fig.14).
FIG.14
Measure from
the cabinet edge.
Mark
Fig.15A
Fig.13B
O
O
1
About1 / to1 /
4
5
Locknut
Sill Angle
Bracket
Flat Head
Bolt
3. Install support brackets(with sill angle
brackets attached) to correct hole in
bottom of cabinet as shown in Fig.16.
4. Tighten all 6 bolts securely.
5
8
Extend W indow Filler Panels
6
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top(Fig.17).
3. Close window behind top angle.
13
1 2 Long Screws
Left
And Locknuts
2 Each Required For
Each Support Bracket
Fig.15B
Fig.16
Fig.17
Right
1 2 Long Screws
and Locknuts
7/16"Locking Screw
and Washer
Advertisement
