Advertisement
INSTALLATION INSTRUCTIONS
Preliminar y Instr uctions
3.
Check your storm windows
window frame does not allow the clearance
required, correct by adding a piece of wood as
shown in Fig.E,or by removing storm window
while room air conditioner is being installed.
4 .
Check for anything that could block airflow
check area outside of window for things such as
shrubs, trees, or awnings. Inside, be sure
furniture, drapes, or blinds will not stop proper
airflow.
5.
Check the available electrical service-
supply must be the same as that shown on the
unit serial nameplate. Power cord is 48 inches
long. Be sure you have an outlet near.
6.
Carefully unpack air conditioner-
packing material. Protect floor or carpet from
damage. Two people should be used to move
and install unit.
Hardware(Packed with the unit)
7/16 inch Locking screw and
Flat washer for window panels
（
3 / 4
Hex-head Screw
Safety Lock
1 / 2 inch Long screw and Locknut
3 / 4 inch Long Flat Head
Bolt and Locknut
Sill Angle Bracket
Lock Frame
windows)(on some models)
3 / 4 inch Long Screw(on some models)
(for Vinyl-Clad window)(on some models)
Locking screw 10X 1/ 4 panhead
screws (for Vinyl-Clad window)(on some models)
NOET: R1 hardware and Weather stripping is only
for Energy star models.
Tools Required
A large flat blade screwdriver; Tape measure;
Adjustable wrench or pliers; Pencil; Level
Socket wrenches; Phillips Screwdriver
-- if your storm
Remove all
or 1/2)inch Long
(For Wooden
Long hex-head locking
screw for top angle, side
retainer 5 /16 inch Long
Foam insert
Window sash
seal foam
Safety Lock
Phillips
R1 hardware
Weather stripping
(10 *3/4 *1/12 )
A.Window Mounting
1
Remove Air Conditioner from Cabinet
NOTE: Remove any packaging material from
cabinet exterior.
1.Pull down front grille and remove filter.
(See Fig.1).
2.Lift f
--
3.Locate the four front screws and remove.
These screws will be needed to re-install
the front panel (see Fig.2).
Power
Fig.1
4.Push metal cabinet side to release plastic tabs
on each side of front panel (see Fig.3).
5.Gently lift front panel off unit(see Fig.3A).
6.Disconnect the connector plug of the display
panel from the unit and place front panel to one
side(see Fig.4).
2 ea.
7
1
Fig.3
4ea.
2ea.
2
2
2
Fig.3A
10
7. Remove shipping screws from top of unit and
also on the side by the base if installed
2
(see Fig.5).
8. Hold the cabinet while pulling on the base pan
1
handle, and carefully remove the unit.
9. Add two foam inserts to holes in top of cabinet
2
where shipping screws were removed from
(see Fig.6).
2
2
5
11
ront grille
upwards and place to one side.
Front Panel
Front Grille
shipping
screws
Fig.5
Fig.2
Fig.4
Fig.6
Advertisement
