Connections; Dmx512 Connection / Connection Between Fixtures; Dmx512 Control - EuroLite LED TMH-51 User Manual

CONNECTIONS

DMX512 connection / connection between fixtures

Device 3
Starting address 33
1: Ground
2: Signal (–)
3: Signal (+)
DMX IN DMX OUT
120 Ohms
The wires must not come into contact with each other; otherwise the fixtures will not work at all, or will not
work properly.
Please note the starting address depends upon which controller is being used.

DMX512 control

A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2 Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
Device 2
Starting address 17
1: Ground
2: Signal (–)
3: Signal (+)
DMX IN DMX OUT
26/36
Device 1
Starting address 1
1: Ground
2: Signal (–)
3: Signal (+)
DMX IN DMX OUT
DMX-512 Controller
00110746, Version 1.2