Connections; Dmx512 Control - EuroLite LED B-200 Hypno User Manual

The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The supplied mounting bracket for fixed mounting of the device has fixing holes for the
attachment to the wall/ceiling
Step 2: Hold the mounting bracket onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Attach the mounting bracket onto the device bottom.
Step 6: Hold the device with the mounting bracket in the desired position and screw it tight.

CONNECTIONS

DMX512 control

DMX Controller DMX Controller DMX Controller DMX Controller DMX Controller DMX Controller
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin XLR
connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2 Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
Device 1
Starting Address 1
Program Program Program Program Program Program
Chase32 Step100 Chase32 Step100 Chase32 Step100 Chase32 Step100 Chase32 Step100 Chase32 Step100
Device 2
Starting Address 25
24/32
Device 3
Starting Address 49
00143647, Version 1.0