Connections; Dmx512 Control - EuroLite LED PLL-2000 RGBALC Panel User Manual

CONNECTIONS

DMX512 control

DMX Controller DMX Controller
Program Program
Chase32 Step100 Chase32 Step100
A DMX512 data link is required in order to control the device via DMX. The device provides 3-pin and 5-pin
XLR connectors for DMX connection.
1 Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2 Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always
connect one output to the input of the next unit until all units are connected.
3 At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX splitter to ensure proper data transmission.
XLR connection:
Device 1
Starting Address 1
ENTER ENTER
24/36
Device 2
Starting Address 12
ENTER ENTER
00146057, Version 1.1
Device 3
Starting Address 23
ENTER ENTER