Operating Mode Following A Power Failure (Autostart); Positioning Tiles - Lauda V1R20 Operation Manual

Switching active Safe Mode off

6.3.3 Operating mode following a power failure (Autostart)

Fig. 17: Autostart with current setting [On]

6.3.4 Positioning tiles

Fig. 18: Positioning tiles
V1
Active Safe Mode can only be switched off on the operating unit. It is not
possible to switch it off via an interface is not possible.
If Safe Mode has been triggered by an alarm, you must reset
the alarm on the constant temperature equipment before you can
switch Safe Mode off.
Refer to your constant temperature equipment's operating manual
to also obtain information about the Safe Mode function specific to
your device.
In general, the device is required to resume operation after a power failure.
However, you can introduce a manual activation step for safety reasons.
1. Open the Home window.
2.
Touch the Settings  Basic settings  Autostart tile.
3. Select one of the following options in the Autostart field:
Off : After the power supply has been restored, the constant

temperature equipment always starts operating in Standby mode.
On : After the power supply has been restored, the constant

temperature equipment starts in the mode in which it was active
when the interruption occurred ( Standby / Operation ).
The tiles available for the constant temperature equipment are sorted in any
order on the Home window. You can the place the most frequently used tiles
in the foremost positions.
1. Open the Home window.
2.
Touch the Settings  Basic settings  Tiles configuration tile.
All tiles appear consecutively numbered in a list.

3. Touch the buttons for the tiles you wish to rearrange.
Symbols and captions are displayed on each of the buttons.
The number on the right of the button indicates its position in
the sequence.
An input window appears for manual entry.

4. Enter a new number.
5. Press the [OK] button to return to the previous screen with the new
setting.
6. Repeat the process for each additional tile that you would like to sort.
7. Tap the [<] button repeatedly until the Home window appears.
The tiles are sorted into the new sequence in the home window.

Command Touch operating unit 21 / 51