Fitting The Cutting Blade - Stihl FC 110 Instruction Manual

English / USA
1
2
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
16

Fitting the Cutting Blade

1
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
5
6
4
3
: Insert stop pin* or Allen wrench* (2)
as far as possible in the bore (3) –
push lightly and rotate it back and
forth together with the thrust
washer (4) until the drive shaft is
blocked.
: Apply combination wrench (5) to
screw (6).
: Loosen screw clockwise (left-hand
thread) and take it out.
: Remove retaining ring, plain washer
and thrust washer.
* see "Guide to Using this Manual"
2
FC 110