Table of Contents
Advertisement
english / USA
Fitting Carrying Eye*
(Clamp)
3
2
1
3
:
For position of carrying eye (clamp)*
see "Parts and Controls"
:
Place the clamp (1) with tapped
hole against the left-hand side of the
drive tube.
:
Place the other half of the clamp (2)
against the right-hand side of the
drive tube.
:
Slide the two clamps together so
that their slots engage.
:
Insert M 6 x 14 screw (3).
:
Line up the carrying eye.
:
Tighten down the screw.
*
see "Guide to Using this Manual"
10
Mounting the Loop Handle
1 2
:
Place liner in loop handle as shown.
A
1
6
5
3
4
:
Fit the loop handle (1) on the drive
tube approx. 8 in (20cm) (A) forward
of the control handle (2).
:
Slide spacer (3) into loop handle as
far as stop.
:
Insert screw (4) in loop handle and
through spacer until the hexagon
head engages the socket in the
loop handle.
:
Fit washer (5) and wingnut (6) and
tighten down firmly.
2
KW 85
Advertisement
Table of Contents
