Trim Assist Center - Yamaha 6X9 DIGITAL ELECTRONIC CONTROL Operation Manual

TIP:
• The engines must not be running when the
desired speed and percentage of trim are
entered into the gauge. It is recommended
that the boat be water-tested to determine
the optimum trim positions at specific
engine speeds for your operating conditions
prior to entering these settings.
• During testing, record the "Current" speed
and percentage of trim information for later
entry into Positions 1–5.
• It is required to enter engine speed and
percentage of trim data in all five positions.
Engine speed for Position 1 is automatically
set for "Idle".
3. Tap "Set RPM" to move to the "Trim
Assist-Set RPM" menu.
4. Enter your preferred engine speed. Tap
"Done" to confirm.
5. Tap "Set Trim" to move to the "Trim
Assist-Set Trim" menu. Set the desired
amount of trim angle in percentage. Tap
"Done" to confirm.
6. Tap "Back" to go back to the "Engine
Menu" screen.
Example:
B
A. Engine speed (r/min)
B. Trim angle (degrees/percentage)

Trim Assist Center

In some applications when using the auto-
matic trim assist feature, boat performance
may be optimal when the CENTER PORT
and CENTER STBD outboard motor is set at
trim angles different than the PORT and
STBD motors. This function allows the setting
of the CENTER PORT and CENTER STBD
motor's trim angles independent of the trim
angles selected when performing the "Set
ALL Trim" function.
Follow the setting procedure below to config-
ure and enable this function on your boat.
44
Trim Assist Center
A