[System] > [Communication] > [Wireless Lan]; Interface; Access Point; Ipv4 - Canon CR-N300 Settings Manual

[System] > [Communication] > [Wireless LAN]
Settings for the access point for directly connecting the camera and the wireless LAN supported devices. By setting
different IP addresses for the Wireless LAN and the Wired LAN, it possible to choose and use according the purposes.

Interface

Settings for use of the wireless LAN.
[Wireless LAN]
Select whether to use the wireless LAN.

Access Point

When [Wireless LAN] is set as [Enable], set the SSID and the authentication method etc., so that the camera functions as
the access point.
[SSID]
Enter the network name (SSID). Enter in single-byte alphanumeric characters, numbers, or symbols.
[Authentication Method]
Fixed as WPA2-PSK/WPA3-SAE mix.
[Password]
Enter a password for the access point. Enter in single-byte alphanumeric characters, numbers, or symbols.
[Confirm Password]
Enter the same password as above for confirmation.
[Channel Setting]
When connecting multiple devices at the same frequency, set the channel to avoid radio interference.
Note
If the SSID is changed, it is also required to change the password.

IPv4

Settings of IPv4 for connecting the wireless LAN and the wired LAN at the same time.
62