Replacing The Filters; Filter Replacement Indicator - Philips AC1213/40 User Manual

6 Replacing the
filters
Filter replacement
indicator
This air purifier is equipped with a
filter replacement indicator to make
sure that the air purification filter is in
optimal condition when the air purifier
is operating. When the filters need to be
replaced, the filter code displays on the
screen.
If the filters are not replaced in time,
the air purifier will stop operating and
automatically lock.

Replacing the filters

Note
• The air purification filters are not
washable nor vacuum cleanable.
• Always turn off the air purifier and
unplug from the electrical outlet
before replacing the filters.
• Do not clean the filters with a
vacuum cleaner.
• If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or contact
the Consumer Care Center in your
country.
10 EN
Filter alert light Action
status
Replace
A3 displays on NanoProtect filter
the screen HEPA Series 3
(FY1410)
Replace
C7 displays on NanoProtect filter
the screen Active Carbon
(FY1413)
A3 and C7
display on
Replace both filters
the screen
alternately
1
Turn off the air purifier and unplug
from the power socket.
2
Take out the used air filter according
to the filter alert light status
displayed on the screen (Fig. y).
Discard used filters.
Note
• Do not touch the pleated filter
surface, or smell the filter as it has
collected pollutants from the air.
3
Remove all packaging material from
the new filter (Fig. f).
4
Place the new filters into the air
purifier (Fig. g).
5
Put the plug of the air purifier in the
power socket.
6
Touch and hold the
to reset the filter lifetime counter
(Fig. z).
7
Wash your hands after changing a
filter.
for 3 seconds