Hamamatsu Photonics C9266-03 Instruction Manual page 7

CCD Data Acquisition Module C9266-03/C9266-04
(3) LED display
Indicates the current operation status of the C9266-03/C9266-04 Data Acquisition Module.
The LED display indicates the following operating modes. These are all displayed by
green.
LED display
Lights out
Fast frequency blinking
Lights on
Low frequency blinking
(4) EXT.TRIG connector
An industrial standard BNC connector used to input external trigger signals when the
C9266-03 is operated in the External Trigger mode. The input signal should be an
H-CMOS level pulse. The internal circuits are optically isolated.
There is not the BNC connector in the C9266-04.
(5) Power switch
The power switch used to turn the C9266-03 on or off. Select how power is supplied by
using the switch position as shown in the table below.
Switch position
Left
Middle
Right
Please take note of the maximum current when power is supplied through the USB
connector.
There is not the power switch in the C9266-04.
(6) DC +5V
A power input connector when using an external power supply. This is an industrial
standard DC power jack (compatible with EIAJ RC5320A, voltage class 2). The center
contact of this jack is positive (+) and the outside is negative (-). Use an AC adapter of
+4.5V/(1A or more) when supplying power through this jack. And if use another power
source, set the voltage at +5V.
There is not the power input connector in the C9266-04.
Mode
Suspend mode
Idle/Sleep mode
Standby mode
Data Transfer mode
Description
Power ON
(Power is supplied through USB connector.)
Power OFF
Power ON
(Power is supplied from external power supply.)
3