Grizzly G0667X Owner's Manual page 49

7.
Figure 68.
8.
Note: To test the backlash, re-install the key
and ball handle onto the leadscrew.
9.
10.
Note: When re-installing the bearing hous-
ing, make sure the way cover mounting
flanges (see Figure 67) are on the top for
proper alignment.
If the bearing housing does not easily slip
onto the alignment pins, use light taps from a
dead-blow hammer or wooden mallet evenly
on all sides of the housing to gradually seat it
against the saddle.
Figure 68
Figure 69
Figure 69.