Pro-Form POWER 795i User Manual page 15

16. Firmly tighten the four 3/8" x 2 3/8" Screws
(7), the two 3/8" x 1 3/4" Screws (62), and the
two 3/8" x 1 1/4" Screws (63).
Next, set the Left Inner Base Cover (50) onto the
lower end of the Left Upright (89). Slide the Left
Base Cover (82) downward and press it onto the
Left Inner Base Cover.
Then, set the Right Inner Base Cover (51) onto
the lower end of the Right Upright (90). Slide the
Right Base Cover (83) downward and press it
onto the Right Inner Base Cover.
17. Press the two tabs (not shown) on the Tablet
Holder (99) into the slots (M) in the console
assembly (G).
Then, attach the Tablet Holder (99) with four
M4 x 16mm Machine Screws (97). Tip: Start
the two upper Machine Screws first, and then
start the two lower Machine Screws. Do not
overtighten the Machine Screws.
IMPORTANT: The Tablet Holder (99) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
18. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see page 26 and 27). Note: Extra hardware may be
included.
16
83
62
63
7
90
17
Start First
97
15
89
82
50
63
7
62
51
99
97
G
M