Table of Contents
Advertisement
ROUTER CONFIGURATION
Use this section to set up an inverter with remote Internet access when located
behind a router.
A router allows multiple PC's to share a single Internet connection, and must be
configured correctly to forward incoming remote data to the local IP address of
your inverter.
Example configuration using a Linksys WRT54G router: (others will be similar)
1. Log into your router and go to the port forwarding screen. In the
example Linksys WRT54G router this is located in the Applications and
Gaming tab. The location of the port forwarding fields may be different
on your particular router. (consult the router manual for instructions)
2. Configure HTTP forwarding:
a.
Enter a unique name in the Application field
b. Enter the HTTP port number that the inverter is using in the Start
and End fields. The default HTTP port for the inverter is 80.
c.
Select Both under Protocol (TCP and UDP)
d. Enter the local IP address of the inverter (e.g. 192.168.0.180) in the
IP address field. (see step 2 of the TCP/IP Web Based Utility section
to verify the inverter IP address)
e.
Check the Enable box, and then click on Save Settings
NOTE:
Many ISP's block access to port 80, so if your ISP does block this port you must
change the HTTP port the inverter uses from 80 to something else, such as 8000.
(Valid port numbers are in the range of 1 to 65535) See the Network Setup
section for information on assigning new network ports.
You must also change the inverter's HTTP port from 80 if your local network has
another device (such as a web server) already using port 80.
3. Configure HTTPS forwarding by repeating steps 2a to 2e with the HTTPS
port number that the inverter is using. The default HTTPS port number is
443.
22
Innovative Circuit Technology Ltd.
All manuals and user guides at all-guides.com
Comm Reset Button
Advertisement
Table of Contents
