Network Setup - ICT Sine Wave ICT1500-12W Instruction Manual

Secondary IP Address: Enter an optional second IP address that the unit can
monitor to verify network status. The Network Watchdog will only trigger if
both the Primary and Secondary IP addresses fail to respond.
Watchdog Timeout: Enter the time (1 to 80 minutes) that the remote IP
address must stop responding to ping requests from the inverter, before the
Network Watchdog will trigger an inverter output power cycle. Ensure this
time is greater than the normal start-up time for the network hardware to
prevent nuisance power cycle events at system start up.
Reset Delay: Enter the time (10 to 240 seconds) that the inverter will wait
before re-enabling its output after a watchdog timeout. This delay must be
long enough for any external networking equipment powered by the
inverter to fully shut off, to force the equipment to re-boot when AC power
is restored.

Network setup

Use this page to configure the network settings for the inverter. Click on the Save
Settings button at the bottom of the page to save any changes and re-boot the
unit.
14 Innovative Circuit Technology Ltd.
All manuals and user guides at all-guides.com
Figure 9: Network Setup Page