Device Setup - ICT Sine Wave ICT1500-12W Instruction Manual

Select any one of the other Inverter web interface pages (such as Device Setup,
or Network Setup etc.) by clicking on one of the blue menu bar items at the left
side of the screen

Device Setup

Use this page to configure the inverter settings. Click on the Save Settings button
when finished to save and implement all new changes.
Device Info:
Device Name: Enter a custom descriptive name for the inverter, if desired
Model: Displays the ICT model number for the inverter
Hardware: Displays the hardware version of the inverter
Network Watchdog:
Watchdog Enabled: Checking this box will enable the watchdog feature,
which will cause the unit to periodically ping up to two remote IP addresses
to verify the network connection status. If there is no response from either
address the unit will cycle the inverter output power. This feature is useful
for re-booting a modem or other network device that is powered by the
inverter, to help recover the network IP connection when one of these
devices has crashed. The inverter output will be held in the off state for the
duration set by the Reset Delay time, and then will be turned back on.
Note that disabling the inverter output on units with the transfer relay
option will not cut power to the load if AC is being supplied by an external
source via the internal transfer relay.
Primary IP Address: Enter the remote IP address you would like the inverter
to monitor. If left blank the unit will monitor the Gateway IP address listed in
the Network Setup page.
All manuals and user guides at all-guides.com
Figure 8: Device Setup Page
Innovative Circuit Technology Ltd. 13