Unpacking and positioning
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
Installation
1. Cut out the installation opening as described on the drawing below.
2. Put four fix bracket to the side of the hob (see picture)(KM9120EN)
3. Check the seal for perfect fit and overall cover. Lower the appliance into place
and align properly.
297
KM 9120 EN
515
287
498
22