Table of Contents
Advertisement
The DIGI-BSR-4K will convert any incoming HDBaseT signal and scale
the video signal to match the native resolution of the connected display.
The scaler chip in the DIGI-BSR-4K presents an EDID of 3840x2160 at 30
Hz to the source device connected to the HDBaseT transmitter. Other
video resolutions are included in the EDID table to provide the greatest
amount of compatibility with the source device.
After the video has been scaled, the DIGI-BSR-4K will sample the
audio stream and de-embed the audio to the analog and digital audio
outputs. Since this is happening after the video scaling, there is no
delay between the audio and video signals leaving the DIGI-BSR-4K.
The output resolution of the DIGI-BSR-4K can be set to a static output
resolution. The de-embedded output audio levels can be raised,
lowered, or muted. The DIGI-BSR-4K can also be configured to turn on
and off the display depending on the state of the source device.
RS232 Wiring
DIGI-BSR-4K
Rx
Tx
Default Device Behavior
Configurable Device Behavior
Display
TXD
GND
RXD
Analog Audio Wiring
L
R
L+
L-
R-
R+
Advertisement
Table of Contents
