Rs232 And Tcp/Ip Commands - Intelix DIGI-BSR-4K-BSTK Installation Manual

RS232 Settings: 57600 baud, 8 Data bits, 1 Stop bit, Parity = None
TCP/IP Settings: User defined IP address (default IP address: 192.168.2.128), port 23
There is a carriage return (hex 0D) and line feed (hex 0A) at the end of every command
and response.
Description
Connect to scaler control
Connect to HDBaseT pass-through
(default)
Connect to HDBaseT upgrade circuit
Get connection status
Description
Set scaler output to 2160p/30
Set scaler output to 1080p/60
Set scaler output to 720p/60
Set scaler output to 1920x1200/60
Set scaler output to 1280x800/60
Set scaler output to display's native
resolution
Description
Display On via CEC
Display Off via CEC
Display Auto On or Off via CEC with
active source
Disable Display Auto On or Off
Display Auto Off with no source
delay time (mins)
Set scaler output to display's native
resolution

RS232 and TCP/IP Commands

RS232 Port Function Commands
Command
CONNECT SCA
CONNECT PTH
CONNECT UPG
GET CONNECT
Scaler Output Commands
Command
SET SCALER UHD30
SET SCALER FHD
SET SCALER HD
SET SCALER WUXGA
SET SCALER WXGA
SET SCALER AUTO
CEC to Display Commands
Command
DISPLAY ON
DISPLAY OFF
DISPLAY AUTO ON
DISPLAY AUTO OFF
DISPLAY AUTO DELAY xx
SET SCALER AUTO
Response
CONNECT SCA
CONNECT PTH
CONNECT UPG
Any above response
Response
SCALE UHD30
SCALE FHD
SCALE HD
SCALE WUXGA
SCALE WXGA
SCALE AUTO
Response
DISPLAY ON
DISPLAY OFF
DISPLAY AUTO ON
DISPLAY AUTO OFF
DISPLAY AUTO DELAY xx
MINUTES
SCALE AUTO