NordicTrack NETL32719.0 User Manual page 30

SYMPTOM: The incline of the incline trainer does
not change correctly
a. Calibrate the incline system (see step 6 on
page 23).
SYMPTOM: The console does not stay in place
a. If the console does not stay in the desired position
because it is loose, insert a hex key in the two indi-
cated locations (E) and turn the hex key in quarter
turn increments until the console is tightened.
a
E
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
E
30
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (F) on the side of
the console. Using a bent paper clip (G), press
and hold the reset button inside the opening, and
have a second person press the power switch into
the on (reset) position. Continue holding the reset
button (F) until the console turns on. When the
reset operation is complete, the console will turn
off and then turn back on. If it does not, use the
power switch to turn the incline trainer off and then
on again. Once the console turns on, check for
firmware updates (see step 5 on page 23). Note: It
may take a few minutes for the console to be ready
for use.
a
F
G