Ethernet Connection - Via Router - SPX CUES flexitrax C550c Operation Manual

8.2 Ethernet connection – via router
Follow the steps detailed below to enable control of your C550c system if your WinCan enabled PC is
connected to your flexitrax C550c controller via a router.
1 Connect the flexitrax C550c controller to the router, and the router to the PC, with Ethernet cables.
Power up the router.
2 From the C550c controller Start-up screen, select
Settings > Network > Ethernet settings
3 Set the IP assignment to Automatic.
4 Select Save & Exit to return to Network settings
5 Confirm that the Ethernet IP matches the new IP address on the C550c controller's Ethernet settings
page
6 Confirm that the C550c controller's Ethernet icon in the top right hand corner of the display shows
that the connection is enabled as shown in Fig. 8-1.
C550c Operation Manual
8 WinCan PC connections
www.cuesinc.com | 257