Table of Contents
Advertisement
During installation in
combustible matter, NIN SEV
1000 and fire protection
guidelines and regulations of
the Association of Cantonal
Fire Insurance shall be strictly
adhered to.
1. Pull the appliance drawer out as far as
it goes and remove it.
2. Place the appliance in front of the
recess and connect the mains plug.
Make sure the cable is free when you
slide the appliance.
3. Push the appliance into the recess.
A = appliance, N = recess
A
A
A
A
160
mm
A 767
20
D
mm
mm
A 549 mm
N 550 (-0,+1) mm
4. Use a minimum of 2 screws to attach
the oven on the 2 sides (A).
When installing next to a wood-fuelled
boiler, a heat-proof and heat-insulating
plate must be mounted at the height
of the appliance and at least 30 cm
deep.
A
600 mm
B
~50 mm
N 762 + 3
A
mm
A 757
mm
A
435
mm
170
mm
N 780
mm
min. 20 mm
B
10
mm
A
20 mm
12.3 Electrical connection
WARNING!
If service is required always
disconnect the appliance
from the power supply.
Use a power cable of H05VV-F or higher.
Install the appliance with a socket supply
line. If there is no socket supply line, the
fixed home electrical system must include
an isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000). The
customer must have a socket for the
electrical connection that is accessible
and outside the coordination room. The
length of the connection cable must be
approximately 120 cm with lines
connected directly to the mains.
Only a qualified person can
connect the appliance to the
electricity supply.
1. Open the mains terminal cover (D).
D
F
2. Put the connection cable into the
supplied rings (E).
This is to prevent the cable from
rubbing against the drawer. The
connection cable is on the housing
side.
3. Install the cable grip (F).
4. Connect the terminal as in the
illustration.
ENGLISH
27
E
Advertisement
Table of Contents
