Table of Contents
Advertisement
Power Supply Cord Connection
Power Supply Cord Strain Relief:
1.
Attach power supply cord strain relief
Remove the screws from a 3/4" (19 mm) UL Listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections (C) into the hole below the terminal block
opening (B) so that one tab is pointing up (A) and the other
is pointing down (D), and hold in place. Tighten strain relief
screws just enough to hold the two clamp sections (C)
together.
2.
Attach power supply cord
to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the
strain relief. The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position. Do not further
tighten strain relief screws at this point.
If your outlet looks like this:
4-Wire Power Supply Cord Connection
A
IMPORTANT: A 4-wire connection is required for mobile homes
B
and where local codes do not permit the use of 3-wire connections.
C
D
4-wire receptacle
(NEMA type 14-30R)
Spade terminals with
upturned ends
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "4-Wire Power Supply Cord
Connection."
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "3-Wire Power Supply Cord
Connection."
4 prong plug
Ring terminals
9
Advertisement
Table of Contents
