Set The Ring Delay; Remote Access - Philips Mira M565 Extended User Documentation

• Press MENU/OK to enter the
options menu.
• Press /
decrease the volume.
Delete an incoming message
1
When you listen to the message,
press MENU/OK to enter the
options menu.
2
Select [Delete], then press MENU/
OK to confirm.
» The current message is deleted.
Delete all old incoming
messages
1
or MENU/OK > [Answer
Press /
machine]
2
Select [Delete all], then press
MENU/OK to confirm.
» A confirmation request is
displayed on the handset.
3
Press MENU/OK to confirm.
» All old messages are
permanently deleted.
Note
•
You can only delete the read messages. No
deleted messages can be recovered.

Set the ring delay

You can set the number of times the
phone rings before the answering
machine picks up the call.
1
Press / or MENU/OK > [Answer
machine]
2
Select [Ring delay], then press
MENU/OK to confirm.
EN
26
to increase/
3
Select a new setting, then press
MENU/OK to confirm.
» The setting is saved.
Note
•
Make sure that the answering machine
is switched on before this feature can be
applied.
Tip
•
When you access the answering machine
remotely, you are recommended to set the
ring delay to [Toll saver] mode. This is a cost
effective way to manage your messages.
When there are new messages, the answering
machine picks up the call after 3 rings; When
there is no messages, it picks up the call after
5 rings.

Remote access

You can operate your answering
machine when you are away from
home. Simply make a call to your phone
with a touch tone phone and enter your
4-digit PIN code.
Note
•
The remote access PIN code is the same as
your system PIN. The preset PIN is 0000.
Activate/deactivate the remote
access
You can allow or block remote access to
the answering machine.
1
or MENU/OK > [Answer
Press /
machine]
2
Select [Remote access], then press
MENU/OK to confirm.