Table of Contents
Advertisement
16 Frequently
asked
questions
No signal bar is displayed on the
screen.
•
The handset is out of range. Move it
closer to the base station.
•
If the handset displays
[Unregistered], register your
handset.
Tip
•
For further information, see the chapter
'Services', section 'Register additional
handsets'.
If I fail to pair (register) the additional
handsets to the base station, what do
I do?
Your base memory is full. Unregister the
unused handsets and try again.
Tip
•
For further information, see the chapter
'Services', section 'Unregister the handsets'.
The range is short. How can I improve
it?
The range is subject to environmental
factors, like electrical devices or walls in
between.
•
Move the base station to another
corner/room.
•
Move the base station away from
other electrical appliances nearby
that could interfere with the range
(like routers, TV, radio, etc.).
•
Do not put the base station on a
metallic desk or a metallic table top.
EN
36
My handset is in searching or
unavailable status, what do I do?
•
Make sure that the base station has
power supply.
•
Move the handset closer to the
base station.
•
Register the handset to the base
station.
I have chosen a wrong language which I
cannot read, what do I do?
1
Press
to go back to the standby
screen.
2
Press MENU/OK to access the main
menu screen.
3
One of the following texts appears
on the screen:
Réglages > Langue
Phone setup > Language
Config. tel. > Idioma
4
Select it to access the language
options.
5
Select your own language.
I have chosen a wrong country in
Welcome screen, what do I do.
Reset your phone settings to the
original factory settings (see 'Restore
default settings' on page 32).
No dialing tone/no free line.
•
Check your phone connections.
•
The handset is out of range. Move it
closer to the base station.
•
The handset is in [searching] or
[Unavailable] status. Register the
handset to the base station.
No docking tone.
•
The handset is not placed properly
on the base station/charger.
•
The charging contacts are dirty.
Disconnect the power supply first
and clean the contacts with a damp
cloth.
Advertisement
Table of Contents
