Table of Contents
Advertisement
Delete all old incoming messages
1
or MENU/OK > [ANSW
Press
/
MACHINE] > MENU/OK.
2
Select [DELETE ALL], then press MENU/
OK to confirm.
» A confirmation request is displayed on
the handset.
3
Press MENU/OK to confirm.
» All old messages are permanently
deleted.
Note
•
You can delete the read messages only. No deleted
messages can be recovered.
Set the ring delay
You can set the number of times the phone
rings before the answering machine picks up
the call.
1
or MENU/OK > [ANSW
Press
/
MACHINE] > MENU/OK.
2
Select [RING DELAY], then press MENU/
OK to confirm.
3
Select a new setting, then press MENU/
OK to confirm.
» The setting is saved.
Note
•
Make sure that the answering machine is switched on
before this feature can be applied.
Tip
•
When you access the answering machine remotely,
you are recommended to set the ring delay to [TOLL
SAVER] mode. This is a cost effective way to manage
your messages. When there are new messages, the
answering machine picks up the call after 3 rings; When
there is no messages, it picks up the call after 5 rings.
Remote access
You can operate your answering machine when
you are away from home. Simply make a call to
your phone with a touch tone phone and enter
your 4-digit PIN code.
Note
•
The remote access PIN code is the same as your
system PIN. The preset PIN is 0000.
Activate/deactivate the remote access
You can allow or block remote access to the
answering machine.
1
or MENU/OK > [ANSW
Press
/
MACHINE] > MENU/OK.
2
Select [REMOTE ACC.], then press
MENU/OK to confirm.
3
Select [ACTIVATE]/[DEACTIVATE], then
press MENU/OK to confirm.
» The setting is saved.
Change the PIN/passcode
1
or MENU/OK > [ANSW
Press
/
MACHINE] > MENU/OK.
2
Select [REMOTE ACC.] > [CHANGE
PIN], then press MENU/OK to confirm.
3
Enter the old PIN/passcode, then press
MENU/OK to confirm.
4
Enter the new PIN/passcode, then press
MENU/OK to confirm.
5
Enter the new PIN/passcode again, then
press MENU/OK to confirm.
» The setting is saved.
EN
25
Advertisement
Table of Contents
