NTI Trinity Tft399 Installation And Operation Manual page 15

Tft Series
Figure 4-3(e) Trinity Tft60-154 & 340-399
Near Boiler Venting (Stainless Steel)
Swing Joint
to attain slope in
horizontal runs
SS Exhaust
Vent
Flue Outlet
Adapter (factory
supplied)
Figure 4-3(g) Trinity Tft201-285
Near Boiler Venting (Stainless Steel)
SS Air-inlet Pipe
FasNSeal Appliance
Adapter (see Table 4-3)
Air Inlet Adapter
(factory supplied)

Air-Inlet - check with applicable local codes for acceptable pipe material.
Exhaust venting must be supported to reduce strain on piping joints. Failure to follow
these instructions may result in damage, serious injury or death.
In Canada, the first 3 ft (915 mm) of vent piping must be readily accessible for inspection.
Installation and Operation Instructions
w/ offset angle to
SS Air-inlet Pipe
account for slope
SS Appliance Adapter
(see Table 4-3)
PPS Appliance Adapter
Air Inlet Adapter
(factory supplied)
Flue Outlet Adapter
PPS Air-inlet Pipe*
Swing Joint
to attain slope in
horizontal runs
Air Inlet Adapter
SS Exhaust
(factory supplied)
Vent
Flue Outlet
Adapter (factory
supplied)
Figure 4-3(f) Trinity Tft60-154 & 340-399
Near Boiler Venting (Polypropylene)
PPS Elbow
PPS Exhaust Vent
(see Table 4-3)
(factory supplied)
Figure 4-3(h) Trinity Tft201-285
Near Boiler Venting (Polypropylene)
│
Trinity
PPS Air-inlet Pipe*
Air-inlet Adapter
(factory supplied)
PPS Elbow
w/offset angle to
account for slope
PPS Exhaust Vent
PPS Appliance Adapter
(see Table 4-3)
Flue Outlet Adapter
(factory supplied)
15