Table of Contents
Advertisement
The torque specifications shown here are approximate
values obtained with a fully charged battery pack.
Torque
Clutch
Setting
Nm
1-5
0.55-1.65
Small screws in softwood.
Medium screws in softwood or small
6-10
1.76-2.42
screws in hardwood.
Large screws in softwoods. Medium
11-15
2.53-3.08
screws in hardwood or large screws in
16-18
3.19-4.40
hardwood with pilot hole.
NOTE: Because the settings shown in the table are only
a guide, use a piece of scrap material to test the different
clutch settings before driving screws into the workpiece.
Selecting Speed
The speed selector is on top of the motor housing.
Allow the tool to come to a complete stop before
changing speeds. See "Applica-
tions" for recommended speeds
under various conditions.
1. For Low speed, push the
speed selector to display "1".
2. For High speed, push the
speed selector to display "2".
Using the Control Switch
The control switch may be set to three positions:
forward, reverse and lock. Due to a lockout mecha-
nism, the control switch can only be adjusted when
the ON/OFF switch is not pressed. Always allow
the motor to come to a complete stop before using
the control switch.
For forward (clockwise) rotation,
push in the control switch from the
right side of the tool. Check the
direction of rotation before use.
For reverse (counterclockwise)
rotation, push in the control switch
from the left side of the tool. Check
direction of rotation before use.
To lock the trigger, push the control
switch to the center position. The
trigger will not work while the con-
trol switch is in the center locked
position. Always lock the trigger
or remove the battery pack before
performing maintenance, changing
accessories, storing the tool and any
time the tool is not in use.
Applications
Forward -
Push from
RIGHT
Reverse -
Push from
LEFT
Lock -
Push to
CENTER
warning
sonal injury, always brace or hold tool securely.
Starting, Stopping and Controlling Speed
1. To start the tool, grasp the handle firmly and pull
the trigger.
NOTE: An LED is turned on when the trigger is
pulled.
2. To vary the speed, increase or decrease the
pressure on the trigger. The further the trigger
is pulled, the greater the speed.
3. To stop the tool, release the trigger. Make sure
the bit comes to a complete stop before laying
the tool down.
Battery Pack Protection
To protect the battery from damage and extend
its life, the tool's intelligent circuit monitors current
draw, temperature, and voltage drops.
In extremely high torque, binding, stalling, and short
circuit situations that cause high current draw, the
tool will vibrate for about 5 seconds, the fuel gauge
will flash, and then the tool will turn OFF. To reset,
release the trigger.
Under extreme circumstances, the internal tem-
perature of the battery could become too high.
If this happens, the fuel gauge will flash and the
battery pack will shut off. Let the battery pack cool
and then continue work.
6
To reduce the risk of per-
Advertisement
Table of Contents
