Overhead Mounting - Chauvet Q-Wash 260-LED Quick Reference Manual

Q-Wash 260-LED QRG
AC Power
Fuse
Replacement
DMX Linking
DMX Connection The Q-Wash 260-LED uses a regular DMX data connection for
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
This product has an auto-ranging power supply that can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
1. Wedge the tip of a flat head screwdriver into the slot of the fuse
holder and pry the safety cap out of its housing. It will pull the
installed fuse with it.
2. Remove the blown fuse from its safety cap and replace it with a
fuse of the exact same type and rating (F 3.15 A, 250 V).
3. Insert the fuse holder back into its place, and reconnect power.
The Q-Wash 260-LED can work with a DMX controller using a
regular DMX serial connection.
If you are not familiar with the DMX standard, please download the
DMX Primer document from www.chauvetlighting.com.
DMX personalities, BASIC, and ADVANCED.
Download the Q-Wash 260-LED User Manual and refer to the Setup
chapter to learn how to connect this product for DMX operation, and
the Operation chapter to learn in detail how to configure this product
for DMX operation.
The Q-Wash 260-LED uses the DMX data connection for its
Master/Slave mode.
Download the Q-Wash 260-LED User Manual and refer to the Setup
chapter to learn how to connect this product for Master/Slave
operation, and the Operation chapter to learn in detail how to
configure this product for Master/Slave operation.
Before mounting this product, read the safety notes at the beginning
of this guide and on page 2 of the product's User Manual. Then,
follow the mounting procedure indicated in the Setup chapter of the
User Manual.
Overhead Mounting
Page 4 of 10
C clamps (not included)
Safety cable (included)
Mounting brackets (included)
Floor Standing