Hanging The Fan; Attaching The Fan Blades - Modern Forms Morpheus Installation Instructions Manual

2. Hanging the Fan

Remember to turn off power at the breaker.
Follow the steps below to hang your fan properly:
1. Disconnect power at the breaker to the fan location. A licensed
electrician must install the fan.
2. Remove 1 of 2 screws from the bottom of mounting bracket and
save for use in Finishing the Installation section. Loosen the other
screw (Fig. 2).
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in (Fig. 2A).
4. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box (Fig. 2A).

3. Attaching the Fan Blades

1. Remove and discard the 2 pre-installed screws on the motor
as shown (Fig. 3A).
2. Attach the fan blades with the blade screws provided (Fig. 3).
3. Turn the fan motor assembly over and install the blade collector
ring with the screws provided (Fig. 3B).
12 Morpheus Instructions
5
FR-W1813