Operating Instructions - Omega OBES6781 Installation, Operation & Maintenance Instructions Manual

OPERATING INSTRUCTIONS

ACCESSORIES
It is recommended that you use the containers indicated depending on the food you will cook in your oven.
You can also use glass containers, cake pans and special oven trays suitable for use in your oven (available in
kitchenware shops). Pay attention to the information given by the supplier for use of this cookware. The
information given below should be implemented for enamelled containers.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer
or if the tray is used to collect the dripping juices of the foods during the grill operation, deformation might be
observed on the tray over time due to high temperatures forming during the cooking/baking operation. This is
a normal, physical state that results during the heat transfer. Do not leave a glass tray or container in a cold
environment immediately after cooking in them. Do not place them on cold and wet surfaces. Ensure that
they slowly cool off by placing them on a dry piece of cloth or wooden board, otherwise, the glass tray or
container might break. If you are going to use your oven to grill, we recommend using the tray shelf on the
tray, supplied together with your product. This way, splattering and dripping oils will not make the oven
interior dirty. If you are going to use the large wire shelves, insert a tray into one of the lower shelf positions to
collect fat or oil. To make cleaning easier, add some water into this tray. In a grilling operation, use the shelf in
the top positions.
When you first run your oven a certain smell will be emanated arising from the insulation materials and the
heater elements. For this reason, before using your oven, run it empty at maximum temperature for 45
minutes. At the same time you need to properly ventilate the environment in which the oven is installed.
In order to cook in your oven, the oven function and temperature setting controls need to be adjusted and the
oven timer, if available, needs to be programmed. Otherwise, the oven will not operate.
Protect your appliance from atmospheric effects. Do not install where it can be affected by the sun, rain, snow,
dust etc.
NOTE: Set up the current time after the power is first connected (or after a power outage). If the decimal point
on the digital display is constantly flashing, the time has not been set.
WIRE SHELVES AND TRAY
The 2 wire shelves come with a built-in safety feature to help minimise them being accidentally pulled fully out.
This comes in the way of a "step", positioned part-way in from the rear of the accessory.
To fit them into the oven, push the wire shelf part way into the oven until the step "catches", then angle the
part over the step & fully insert. To remove, repeat the operation in reverse.
The tray comes with a removable wire handle. Hook the handle over the front edge of the tray and adjust the
handle to the horizontal position. To remove, angle the handle back up while the tray is supported.
EASY DECISION
8