Table of Contents
Advertisement
2.8 Attaching the Belt Clip
The printer can be attached to the waist belt with a Belt
Clip.
Below are recommendations how to attach the Belt Clip:
How to attach it
1. Please remove the screw for the Belt Clip on the back of
the printer.
2. Please tighten the screw of the Belt Clip after setting it
in the desired direction.
Important
- If the Belt Clip is misaligned, it cannot be installed correctly.
- There are two tapped holes in the Belt Clip. The hole which is
used depends on the desired direction clip.
2 Preparation to Print
23
Advertisement
Table of Contents
