Battery Exchange - Yamaha Revolabs FLX2 System Manual

Battery Exchange

The rechargeable batteries in the different FLX components can all be exchanged.
Please note that only Revolabs approved batteries should be used for the replacement.
The following sections explain how to change the batteries in the different components.
We recommend charging any component for 8 hours after exchanging the battery.
Caution: Risk of explosion if batteries are mishandled or replaced by an incorrect type. Do not
disassemble batteries or attempt to charge outside the system. Do not dispose of batteries in
fire. Dispose of batteries in accordance with manufacturer's instructions and local regulations.
Replace batteries only with approved batteries! Please contact Yamaha Unified
Communications, Inc. (uc.yamaha.com) or your AV service provider for correct manufacturer
approved and recommended replacement type batteries.
Microphones
To exchange a microphone battery push the bottom part of the back cover slightly
down towards the charger port and then lift it as shown in the illustration below.
Carefully take the battery out of the plastic cover. Put the new battery into the back
cover as shown in the figure below. Press on the battery until it snaps into the back of
the microphone housing.
Slide the back of the microphone back in place. Place the microphone back into the
charger base. The LED should go on indicating the charge status of the microphone.
51